Product Overview
Chlorine-free Spa Magic 500ml - Pack of 2
- Mde from14 natural seaweed enzymes based spa treatment. It works best at a higher pH than normal. After balancing the spa, raise pH to around-8.0
- Only active in HOT water. Do not try to use it in a low temperature environment. Ensure the water is over 35 degrees Celcius
- Works through the action of natural enzymes
- No oxidizing action, contaminants can only be caught in the filter
- 100% bio-based- completely bio-degradeable
- Chlorine-free or bromine toxicity
- Causes no itching, rashes or burning eyes
- Daily maintenance and testing free
Eco friendly 90 day water care formula for hot tubs: One bottle of Spa Magic keeps your water clean and fresh for up to 90 days. Spa Magic (500 ml) is suitable for spas up to 1000 litres and lasts up to 2-3 months.
How does Spa Magic work?
- Uses 14 natural seaweed enzymes to treat your spa water and keep it clean, fresh and sparkling bright for up to 90 days - without the use of any toxic chemicals.
- Through advancement in water treatment, the unique and powerful formula of seaweed enzymes, specifically designed to keep your spa clean and healthy.
- Enzymes are used by cutting edge biochemists against disease because breaking down bacteria and viruses, dissolving them away, keeping your spa clean and clear for up to 90 days.
- Non-toxic, easy to use, and economical. Daily testing is not required to make sure the chlorine and bromine levels are right.
- Does not cause the rashes, itching, burning red eyes, and dry skin that chlorine and bromine do.
- There is no nasty chemical odour; no shower needed after you get out of your spa leaving the skin will be soft and silky smooth after each use.
- Attracts oils and other contaminants, then dissolves them away, eliminating them without the use of harsh chemicals.
- Contains lanolin which softens your spa water keeping minerals up along the water line, thus eliminating the spa equivalent of ‘bath tub ring’.
- Does not contain dangerous chemicals
2-Step directions for use in ordinary tap water: Unless your spa is brand new, you will need to remove all excess build-up of contaminants in your spa’s system by using a bottle of Spa Magic as a conditioning Cleanser before using Spa Magic for daily use. We suggest you do not use the spa during the cleanser process.
Step One: Spa Magic Spa Cleanser
1 Remove your cartridge filter for the duration of the cleanser process. We also recommend you clean or replace your filter at this time.
2 Shake bottle well before use and pour a bottle of Spa Magic into the old water. If the spa is 2-3 years old or more, use two bottles.
3 Let the spa circulate with the water temperature between 35-37ºC for a minimum of 8 hours per day, for 5 days.
4 After 5 days, drain the old water from the Spa - when the water level reaches the footwell use a hosepipe* and add fresh water whilst still draining. This will flush the water from the lower pipework, do this for 10 minutes, clean and refill Spa.
5 Clean both sides of the cover with some of the Spa Magic and rinse thoroughly. If the cover has any breaks or tears, we recommend it be replaced.
*When using a hosepipe please ensure it is flushed thoroughly before use
VERY IMPORTANT
If your spa cover has a zipper closure it is important to unzip the cover (DO NOT REMOVE THE COVER - IT’S DIFFICULT TO PUT BACK ON), and flush the inside with your garden hose. The inside has been known to harbour molds, mildew and bacteria - all of which drip from condensation through the cover back into the spa water.
Step Two: Spa Magic
Fill spa with fresh water. Balance water as normally recommended.
- For spas of 1000 litres, add ½ cup of Spagard Hardness Increase to a bucket of water, dissolve with a wooden paddle, then add to spa with jets running for 5 minutes.
- For spas of 1000 litres, add ½ cup of Spagard Alkalinity Increase to a bucket of water, dissolve with a wooden paddle, then add to spa with jets running for 5 minutes.
1 Shake bottle well before use and add a 500ml bottle of Spa Magic to spas up to 1000 litres.
If your spa is greater than 1000 litres , add proportionally more.
2 After the water has reached the desired temperature (35-39ºc), check the pH level to ensure it is around 8.0 (slightly higher than normally recommended for chlorinated spas). Spa Magic works best at this pH level. You initially may need to check your pH levels on a weekly basis, although the Spa Magic should maintain the level automatically. Use Spagard pH Incresae to raise pH, if necessary. Add a dessertspoon at a time, with jets running and retest pH after 5 minutes.
3 Rinse your filter every week or more frequently - based on bather usage. Use a jet attachment on the hose pipe to rinse thoroughly. Soak the filter in a filter cleanser overnight every 4 to 6 weeks, rinse with water and allow to dry before replacing.
4 Drain and refill your spa and add Spa Magic every three months.
We recommend the weekly use of Spagard Natural Clarifier Product to keep your water sparkling clear. After each application of Spagard Natural Clarifier run the spa for 20 minutes.
ENJOY a completely natural, low maintenance, skin conditioning product, made exclusively for the hot tub industry!
Additional Hints and Tips for using Spa Magic
We do not recommend using any fragrances because they may not be compatible.
Spa Magic is a positively charged ion. Your tubs’ surface has a negative charge. Once in a 90-day period, they will bond, and you will notice a slight film develop on the surface of your tub. All that you need to do is wipe the inside of your tub with a clean cloth or sponge to break this bond. The great result of this bonding is that it also creates a natural lubricant within your spa, coating your heating element, pump, seals and your plumbing - allowing your tubs’ mechanics to work longer and better.
At times you may experience an organic smell. This simply means Spa Magic has found contaminants and is working harder. This may suggest your filter requires more frequent cleaning. Make sure the pH is around 8.0. Check to make sure the underside and inside of the cover has been cleaned. If the odour is still present after 24 hours, some Spagard Natural Clarifier or an Oxidiser may be used.
Spa Magic is compatible with ozonators, chlorine and bromine.
Cloudy water may be caused by frequent use by a large number of bathers, lotions, oils, deodorants, sunscreens or other products used on the skin or soap residues in bathing suits.
Model: SPAMAGIC-P2
Sold individually.
Disclaimer: Any advice or suggestions above, including but not limited to instructions and dosing rates are intended to be a guide only. Spa Store and its staff recommend you read the full instructions on all chemical containers. Spa Store will not accept responsibility for the use of these products. Spa chemicals cannot be shipped to a Post Box. Please provide a physical address during checkout.
Still not sure this is the correct product? Contact our Water Treatment Experts.
