Buy 2 or more and Save 20% more!
OMNI Spa pH Anchor 1L
For greater comfort and softer spa water.
Phosphate buffer that maintains stable pH, softens water and inhibits corrosion in spas and hot tubs.
- Maintains stable, comfortable pH for up to 60 days
- Softens spa water
- Protects equipment
- Simplifies water balance
- Storage and transport friendly
- Improves heater efficiency
If Calcium Hardness is <150ppm: Add 500mL of OMNI Spa pH Anchor per 1,000 litres directly into the spa with the pump operating and heater off.
If Calcium Hardness is >150ppm: Add 500mL of OMNI Spa pH Anchor plus an extra 40mL per 1,000 litres for every 10ppm of Calcium hardness above 150ppm.
Add directly into the spa with the pump operating and heater off. Add an additional 30mL of OMNI Spa pH Anchor per 1 000 litres once a week to maintain proper pH levels. After dosing your spa with OMNI Spa pH Anchor, you may notice some initial cloudiness. This indicates that the product is working. It is recommended that you run your filter to clear the cloudiness. Monitor your filter pressure during this time and backwash as necessary. The water should clear completely within 24 hours. The heater MUST remain OFF until the spa is clear of any cloudiness.
Any advice or suggestions above, including but not limited to instructions and dosing rates are intended to be a guide only.
Spa Store and its staff recommend you read the full instructions on all chemical containers.
We will not accept responsibility for the use of these products.
Spa chemicals cannot be shipped to a Post Box. Please provide a physical address during checkout.